• Automatic Octane adjustments, full time closed loop fueling
• NEW FOR 2023, End of Injection adjustments for top end power carrying to redline
• NEW FOR 2023, M1000RR 23 race pack and ign cut shifter added
• Designed with or without our velocity stack system
• Corrected QUIET start idle specific to Stage 2
• Re-calibrated timing for maximum power
• Lower max lambda, leaner high RPM Target for maximum power
• Higher RPM limit without throttle cut for racing
• Perfected fuel correction for Race gas or E85 fuels
• 20% faster up and downshifts
• Can utilize our optional IAT extension kit and intake flapper removal kit

• Octane adjustments for auto adaptation on pump gas for US and international fuels 91-94 octane 95-100 RON. Utilizing the multiple ignition maps and factory widebands, we are able to increase performance based on knock detection. This also means if you have some bad fuel, the motorcycle will still compensate and put the bike into safety mapping just like the OEM ECU would. This ensures your bike stays consistent and reliable.
• Corrected cold/warm start idle for finer tuning beyond Stage 1. Stage 2 goes a step further. There is no longer a high idle that transitions into a lower idle. The idle remains static without any lean popping, idle hunting or stalling.
• Re-calibrated timing for higher octanes to make use of race fuels on same tune. The 2023 S1000RR has multiple ignition maps and based on knock feedback, the bike will start to adjust to different timing maps. This means if you have a high octane fuel in the bike or race fuel and knock isn’t present, the bike will transition to a more aggressive timing map automatically. A more aggressive timing map will safely allow the bike to make more power. No more flashing every time you want to use race gas although we can still provide specific race fuel mapping designed to be used on ONLY race gas. This feature is most beneficial when you are on the track or street and don’t have your handheld available to swap maps.
• Lower max lambda, leaner high RPM Target for a few more horsepower. AFR (air/fuel ratio) adjustments have been made to Stage 2 to be more aggressive to get a little more power out of the bike while remaining safe.
• Higher RPM limit without throttle cut for racers (optional) With Stage 2 we are able to raise the RPM limiter to 15,000 RPM while also making sure the raised RPM event is not stored in the ECU. We have also adjusted the spark and fuel cuts so when the rev limit is hit, the bike doesn’t feel like you slammed on the brakes, it’s more gentle now.
• 30% faster up and downshifts over Stage 1 and now allows the use of fast shift sensor products on the market if desired.

DYNO

RESOURCES / DOWNLOADS

DOCUMENTS

Device Reset FAQ and How-To PDF

BT Moto Handheld Instructions

BT Moto Flasher+ Troubleshooting Guide

VIDEOS

Review Video

How To Install IAT Relocation and Flapper Removal Kit

How To Install BT Moto Velocity Stacks

How To Install Handheld Tuner