EBC Brakes GPFAX Sintered Road Race Brake Pads Front - GPFAX447HH

This listing is for one package of EBC Brake Pads. One package = one caliper. If your bike has dual calipers please order 2 sets.

GPFAX Sintered Road Race Brake Pads are for RACE ONLY use. This is a blend of brake pad that has higher friction and far better grip than any other brake product on the market.

GPFAX Sintered Road Race Brake Pads have by far the highest known friction with a measurement between 0.6 and 0.7 and deliver the most amazing brake effect. Because of this factor, they are unsuitable for street use or for road tyres. Zero brake fade is guaranteed and the heat stability of these brake pads is perfect leaving the racer with high confidence and a product that can be used over numerous races.

Attributes:

• ONLY FOR RACE USE
• Highest performance friction level known
• NOT R90 street legal or TÜV tested
• Guaranteed for lifetime performance

GPFAX Sintered Road Race brake pads are a closed circuit use pad only and street/highway riding with this material is highly inadvisable and dangerous. Such high friction levels as delivered by these pads are for ideal track conditions with race tyres or slicks on prepared asphalt surfaces and NOT for use with highway tires or on the highway. This material is not ECE R 90 approved nor TUV tested with a German ABE and use on the highway is therefore illegal in many countries.

Tech Info:

The material quickly builds from an initial friction level of 0.6 ( which in itself is a massive brake friction level rarely achieved by any competitor material) up to a huge 0.7 with a minimum in stop friction level of 0.65. This tiny fall off from 07 – 0.65 during braking would be almost undetectable by the rider allowing superb brake feedback and control at the lever and allowing feathering of the brake predictably and steadily throughout deceleration.

The new material also wears better and causes lower rotor/disc damage that previous materials and should be good for 4-5 race events of typical 20-25 lap duration minimum. Pads should be discarded when less than 2.5 mm of friction material remains to avoid fluid vapor lock due to excess piston fluid volume.

This material contains no toxic lead nickel or zinc which is a trick used by our competitors to ramp up friction levels the cheap way.

Preparing your Race discs/rotors before using this Compound

Many pads contain carbon particles some in high percentages and this leaves a grey glaze on rotors. This MUST be removed by fine abrasive paper or what is known as a Scratch Pad in the USA. Take care not to promote deep scratches on the rotor which will cause prolonged bed in times.

Bedding in your new brake pads

After installing the pads ride the bike for 2 laps very gently applying the brakes well in advance of where you wish to stop at speeds not exceeding 80 MPH.

Proceed a further 2-3 laps gradually increasing the brake load until you feel the pads become stable and predictable.

Bedding in to worn or distorted discs/rotors will be dramatically longer.

Inspect pads every Race for wear on EACH pad and replace when any single pad is down to 2.5 mm or lever becomes spongy. Different brake systems respond differently and have differing amounts of fluid in their piston chambers and the time for ideal replacement of the pads due to loss of brake feel can only be assessed by the individual rider and bike

Product Video:  Click here

STATEMENT ON RACE USE OF EBC BRAKES®

Racing is a dangerous sport and EBC wishes to advise all users that any and all liability using any EBC products for any kind of Motorsport, track day event or racing lies purely and exclusively with the user. There is no liability or guarantee nor responsibility accepted by EBC brakes or its affiliates or officers for incidents or costs occurring in such race use.

Warning:

EBC Brakes do NOT recommend or endorse metal matrix, ceramic or composite discs and EBC brakes pads are NOT compatible with these and will cause DISC damage. If in the years to come this changes, this message will be modified.