AELLA Carbon Fiber Frame Cover Heat Shields for the Pangiale V4 / R / S / Speciale (2020+)

So yes, these are much larger than any one else's Frame covers.  Why? because they can lower the heat you feel by 12-15 degrees Celsius (21.6 - 27 degrees fahrenheit)!!!

AELLA is the only one that has a flowing, Single design that covers not only the cover that covers the frame, but also the rear parts. It is a special part with a presence that is discreet without spoiling the beautiful cowl design of V4.  The V4 generates a lot of heat from the surrounding of the engine, and when the heat is transmitted to the frame and the temperature gets too high, Even in leathers, its hot!   AELLA measured a maximum of 74 ° C on the left side and 68 ° C on the right side at the part where the knee and the frame contacted (measured with a non-contact type thermometer), but after installing these, the temperature dropped from -12 ° C to -15 ° C!  The shape of the cover is also easier to handle when braking (leg squeezing).  It also considers the hole position for heat dissipation.

- Because there is almost no clearance between the OE cowl and the frame when attaching to the V4 R , it is necessary to trim the OE cowl where it interferes with these covers

- Wet carbon matte paint finish - Glossy Finish is available upon request.

- Fixed double-sided adhesive tape already attached.

- Thermal insulation sheet to be attached to the inner part where the knee and frame are in contact is also included. The thermal insulation sheet is a 10cm square double-sided tape type. Can be cut freely with scissors.

NOTE: Regarding installation, the interference with this product will change depending on the mounting tolerance of the cowl of the vehicle.  Please keep in mind that the cowl paint may be damaged by vibrations etc. if used with interference.