Honda CBR1000RR-R /SP (2024+) Velocity Stack Kit

The perfect modification for your  Honda CBR1000RR-R engine. 3D printed from lightweight composite, the BT Moto Velocity Stacks have been carefully engineered and designed to maximize power in the higher RPM range while not losing power in the low RPM range.

Made for a perfect fit, the BT Moto velocity stacks have a relief notches at the bottom of each funnel to ensure tight fitment while also being easy to install. These are plug and play and require no additional modifications to your airbox to fit. Simply unscrew your factory velocity stacks and screw ours in. Coupled with our engineered flash, the combination makes an extremely easy install and tune that can be done in your own garage.

DYNO

Graph  (Stage 2 With And Without Aftermarket Velocity Stacks):Below is our Stage 2 flash with a exhaust system with and without aftermarket velocity stacks. You can see little to no loss in the mid and low-range RPM. Up top you can see a significant gain. All on pump gas 93. Same day testing on the same bike.

BT MOTO STAGE 1, 93 Pump Gas:  192whp / 81wtq

BT MOTO STAGE 2, 93 Pump Gas + Velocity Stacks: 201whp / 82wtq

BT MOTO STAGE 2, 93 Pump Gas + Velocity Stacks:  201whp / 82wtq

BT MOTO STAGE 2, MR12 Race Fuel + Velocity Stacks: 213whp / 90wtq

STOCK EURO CBR, Pump Gas:  RED

BT MOTO STAGE 2, Pump Gas: BLUE

**All in-house testing performed with 93 octane pump gas, unless otherwise stipulated. Different modifications and dynometers may make different power. Usage of a lower octane will yield smaller power gains. All power is measured from the wheel and not the crankshaft, whp (wheel horsepower) and wtq (wheel torque)**

RESOURCES / DOWNLOADS

DOCUMENTS

Device Reset FAQ and How-To PDF

BT Moto Handheld Instructions

BT Moto Flasher+ Troubleshooting Guide

VIDEOS How To Install Handheld Tuner

How To Install BT Moto RSV4 Velocity Stacks