Ducabike Performance Technology In-Line Radiator Coolers for the Ducati Hypermotard 950 / SP

We all know the Ducati is a very Hot Blooded Motorcycle (in more ways than one!!)  Bring at least one of those under Control with these Additional Radiators that Go IN-LINE Replacing the two larger Coolant lines!

 Easy to Replace and they bring temperatures down an additional 6-8 degrees, and a cooler motor equals Better Performance!!  Both units include Silicon Hoses and Rolled Edge Steel Clamps (wont cut into the Hoses) and are Machined From Billet Aluminum

The "heart" of these can be found in one component: the custom made extruded tube which allows to transfer and dissipate heat to the outside through its winglets. These winglets can be found both in the inside and outside of the tube.

The tubes are assembled in a unique way as well - no soldering or flanges instead, they use suitable units properly carved-out from the block. Provided with two safety pieces made with Viton, these units allow water and oil flow entry and exit as well as air with the intercooler.

Settings are extremely adjustable, one or more together-built tubes, depending on how one needs them to be.

Weights are the same, or even lower than some other pipes and it's not unusual that this kind of device to represent the only way to reach a sensible reduction for the temperature. There are simple and cheap and no need to add any other radiator or to reposition the OE radiator